Logik L160STB11, Instruction Manual

Page: 9 / 44

9
Battery Replacement of the Remote Control
1. Remove the battery compartment cover.
2. Load 2 x AAA (UM-4 or R03) batteries into the battery
compartment. Close the battery compartment cover.
1
3
2
Handling the Batteries
• Take care of your fingernails when you press and hold the battery release tab.
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could
cause fire, personal injury or damage to property.
• Install the batteries correctly by following the polarity (+ and -) indications in the battery
compartment.
• When the batteries are exhausted, the remote will not function. Replace both batteries at
the same time with new ones.
• Use only the types of the batteries which are indicated in this manual.
• Do not install new batteries with used ones and do not mix different types of batteries.
• Do not dispose of the used batteries as domestic waste. Dispose of them in accordance with
the local regulations.
• If you are not going to use the unit for a long time, remove the batteries to avoid change
from battery leakage and corrosion.
Handling the Remote Control
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of
excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as it
could cause corrosion or battery leakage and may result in physical injury and/or property
damage including fire.
Remote Control Operation Range
Point the remote control unit within approx. 6 metres
from the remote control sensor on the unit and within
60° in front of the unit. The operating distance may vary
depending on the brightness of the room.
Install the batteries correctly by following
the polarity (+ and -) indications in the
battery compartment.
30° 30°
6M
L160_250STB11_IB_final110705.indd 9 05/07/2011 4:28 PM