14
Guardian Alert 911
tm
What to do:
1. Press the “SET UP” button on the BASE UNIT until the red
“SCANNING” light comes on. Release the SET UP button.
2. Now press and hold the EMERGENCY BUTTON
and
the
TEST BUTTON buttons (on the pendant)
at the same time
until it beeps and the “SCANNING” light on the BASE UNIT
goes out.
What to expect:
The red light on the BASE UNIT will blink, and the pendant
will blink red and green when 2 buttons are pressed at the
same time. Both lights blink for a short while until the
pendant beeps and the Setup light goes out. This indicates
the PENDANT and the BASE UNIT are synchronized. At
this point, everything should be working fine.
Now perform the System Check (page 10) test again to make sure all is well.
If your Guardian Alert 911 is still not working, call our TECH SUPPORT
department at 1-800-519-2419.
Information The FCC Wants You To Know:
FCC ID: TYD3091160
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Privacy of communications may not be ensured when using
this phone.
