RTCU LX5 eco Technical Manual V1.00
Advanced Industrial M2M/IoT Gateway
Logic IO ApS.
Ph: (+45) 7625 0210
Holmboes Allé 14
Fax: (+45) 7625 0211
8700 Horsens
Page 28 of 33
Email: [email protected]
Denmark
Appendices
Appendix A
–
Assembling/disassembling the device
It is necessary to take the device apart to get access to the internal SIM-card reade and
configuration jumpers. The bottom part of the encapsulation can be removed after removing the
four Torx T7 screws found in each corner.
Please follow the following steps to get inside the device:
1.
Place the device upside-down on a plain surface. Please make sure that the surface is soft to
avoid scratching the top of the encapsulation.
2.
Remove the four screws located on the corners using a Torx T7 screwdriver.
3.
Lift the bottom part of the encapsulation carefully upwards.
The SIM-Card reader and the jumpers are located as follows:
The assembly process of the encapsulation is in the reverse order of the above steps.
Please notice that the screws must be fastened with a
torque of max. 0.5 Nm
to avoid damaging
the encapsulation.
RS485 line
termination
CAN bus
line termination
CAN bus
write enable
SIM-Card
Reader
