LOGAN FRIABILITY TESTING SYSTEM
FAB-2S FRIABILITY TESTER
Page
7
of
12
4.0
INSTALLATION AND SET UP
4.1
Remove the unit from packing box.
4.2
Remove both drums from packing box.
4.3
Remove drum nut from Friability Tester
4.4
Install drums inf. Shafts. Both drums are marked.
One marked “L” goes to left side.
One marked “R” goes to right side.
Make sure the drum drive slot engage with drive bar and tighten with drum nut.
4.5
Connect the power cord to the Friability Tester
5.0
Operating Procedure
5.1
Turn power switch on.
5.2
Select timer mode or counter mode by pressing “Timer/Counter” button.
5.3
Timer Mode:
With Timer indicator light on, display will show a default time of 0:04:00.
This means when “Start/Stop” button has been pressed drum will rotate for 4 minutes
and then stop.
To Set Test Time:
(Make sure timer mode indicator light is on before proceeding.)
Set Seconds:
A.
Press “set” button, the last digit will start flashing.
B.
Press “Enter” to increase the flashing digit. (Skip step B if no change is required.)
C.
Press “Set” button, the second to last digit will start flashing.
D.
Press “Enter” to increase the flashing digit. (Skip step D if no change is required.)
0:00:0
0
0:00:
0
0
