LOFTNESS Kwik Trim 53, Owner'S Manual And Parts Book

Page: 26 / 94

14 Kwik Trim 53
When the boom assembly is extended into operating
position, the sensor (4) will activate and enable the raise/
lower functions.
Retracting Boom to Transport Position
Press the left side (3) of the foot pedal to retract the boom
assembly back into transport position.
The engine RPM must be raised above idle to extend the
boom.
NOTE: The boom must be raised or lowered until
parallel with the ground before retracting the
boom assembly.
Retract the boom assembly until the boom stops.
NOTE: Once the sensor contacts the top of the boom,
raise/lower functions are deactivated.
Hydraulic Controls
NOTE: This section refers to the front, rear, left and
right of the machine as seen when sitting in the
operator’s seat with the dozer blade visible to
the front.
Extending And Retracting the Boom from
and to Transport Position
Before any boom operations such as raising, lowering,
and tilting can be performed, the boom must be extended
from its transport position. And before transporting, the
boom must be returned to its transport position.
Raise the top (1) of the right foot pedal to unlock the
pedal.
Extending Boom into Operating Position
Press the right side (2) of the foot pedal to extend the
boom to operating position.
The engine RPM must be raised above idle to extend the
boom.
NOTE:
An extend/retract sensor locks and unlocks the
boom raise/lower functions on the foot control.
Operating Instructions
4
5
1
3
2
LOCKED UNLOCKED