LOFTNESS GrainLogix GBU 12, Owner'S Manual And Parts Book

Page: 20 / 108

14 Grain Bag Unloader OM
Set-up Instructions
Installing Grain Bag Unloader to the
Tractor
Back the tractor up to the hitch of the unloader . Insert
pin (1) (1-1/8 in . to 1-1/4 in . pin) and secure with retaining
clip (2) .
WARNING:
Never use a clevis to clevis type
connection to secure the implement to the
tractor. The machine could separate from the
tractor if a clevis pin fails.
Install the safety chain around the tractor drawbar (1)
and install the hook (2) onto the chain .
Remove the PTO driveline from the stored position .
Retract sleeve (1), slide the PTO driveline onto the
tractor PTO shaft until the sleeve slides forward and
locks driveline to shaft . Push and pull the PTO driveline
back and forth several times and make sure it is securely
attached to the PTO shaft .
NOTE:
The PTO driveline is telescopic to fit most
lengths. Minimum distance between crosses
is 37.8 inches (96 cm) and maximum distance
between crosses is 53.5 inches (136 cm). If
the distance is more or less than that, refer to
the PTO driveline manufacturer’s literature for
procedures for adjusting the length. It may also
be possible to move the draw bar location on
the tractor.
Install the 7-pin electrical harness to the tractor’s
electrical connector .
NOTE: If your tractor is not equipped with a 7-Pin
electrical connector, an adapter or special
wiring may be needed.
Secure the electrical harness up and away from the PTO
driveline area .