LOFTNESS 41BX30, Owner'S Manual And Parts Book

Page: 28 / 62

18 Battle Ax OM
Lubrication (Cont’d)
Grease Points Location (Cont’d)
2
8
Location:
Hook end rotor bearing (2).
Interval:
Every 8 hours of operation.
Overhung Load Adapter
The front and rear motor covers must be removed to
access the lubrication points on the overhung load
adapter. Refer to “Removing Motor Covers” on page
19 for removal instructions.
1
2
Remove the plug from the top port (1) on the overhung
load adapter (OHLA). Place a catch container below the
plug for the bottom port (2) on the OHLA and unscrew/
remove the plug. Reinsert the bottom port plug after oil
has drained out.
Using a funnel, add hydraulic oil into the top port
(approximately 6 oz.).
Maintenance
Reinsert the plug back into the top port and tighten.
NOTE: If replacing bearings or seals in the overhung
load adapter, be certain to refill with hydraulic
fluid after reassembly.
Removing Belt Cover
DANGER: Shut down and lock out power
from the excavator before removing the belt
covers. Failure to do so could result in serious
injury or death.
2
13x
1
To remove the belt cover (1), unscrew the thirteen bolts
(2) and lift the cover off of the frame.
CAUTION:
The belt cover is heavy. Support
the cover when removing.
When maintenance/repairs are complete, return the
covers back into position and tighten and secure all bolts.