LOFTNESS 180DW, Owner'S Manual And Parts Book

Page: 41 / 104

29 30' Draper Windrower Shredder OM
Preliminary Draft 08.05.13
Maintenance
Grease Points Location (Cont'd)
Use a #2 general purpose lithium based grease unless
noted otherwise.
NOTE: Replace any broken or missing grease fittings.
Be sure to clean fittings before greasing.
NOTE: Grease points on the machine are indicated on
the machine by the decal shown above.
WArNING: Do not lubricate parts while the
machine is running.
Numbers below after “Location” correspond to grease
point locations on opposite page.
See “Draper Windrower Shredder Identification” on page
8 for component location and identification.
• rear Wheel Grease Fittings
Location: (1-4) - Four fittings located on the pivot of
each of the
four
rear wheel assemblies (16
grease points total for the four rear wheels).
Interval:
Every 100 hours of operation.
• rear Wheel Lift Tube Grease Fittings
Location: (5 - 24) - Four fittings in each of the five rear
lift tubes.
Interval: Every 50 hours of operation.
• Conveyor Belt Grease Fittings
Location: (25, 26, 27, 28) - Located on the ends of the
conveyor belt, both front and back sides.
NOTE: #25 located behind conveyor motor.
Interval:
Every 8 hours of operation.
• Line Shaft u-joint Grease Fittings
Location: (43, 44) - Located on the U-joints on each
side of the gearbox. Access via holes on top
or side of gearbox/line shaft shields.
Interval:
Every 25 hours of operation.
• Front Wheel Grease Fittings
Location: (39-42, 47-50) - Four fittings located on the
pivot of each front wheel assembly.
Interval: Every 100 hours of operation.
• rotor Bearing Grease Fittings
Location: (30, 37, 45, 46) - Located on the left and
right ends of the draper windrower, behind
the belt shields. Lubricate the fitting through
the opening in the frame.
There are also two fittings on the bearings
located where two rotors meet (3 places).
Access those fittings from underneath the
draper.
NOTE: Rotor bearings cannot be damaged by
overgreasing. Grease fittings until a small
amount of grease is purged from the bearing.
Interval:
Every 8 hours of operation.
• Belt Tensioner Grease Fittings
Location: (29, 36) -
Located on the left and right ends
of the draper windrower, behind the belt
shields. Fitting located on end of protruding
shaft.
NOTE: Remove the belt cover when lubricating the fitting.
Visually inspect the idler pulley components
while lubricating. Do Not over lubricate the idler
tensioner shaft.
NOTE: Over lubricating may be transferred to the belt,
causing the belt to slip, resulting in loss of rotor
RPM speed and loss of power to the rotor
Interval:
Every 8 hours of operation.
• Line Shaft Grease Fittings
Location: (31, 38) -
Located on the left and right ends
of the draper windrower, behind the belt
shields. Lubricate the fitting through the
opening in the frame.
Interval: Every 8 hours of operation.
• Pillow Block Grease Fittings
Location: (32-35) - Located on pillow blocks on line
shafts between the gearbox and the end
plates.
Interval:
Every 25 hours of operation.
Continued on next page.