21
Windrow Crop Shredder OM
Jack Stands
IMPORTANT:
During operation and transport, the jack
stands should be locked in their highest
position.
Belt Tension
If adjustments need to be made, see “Belt Adjustment”
on page 39 for instructions.
IMPORTANT:
To avoid damage or excessive wear,
always engage or disengage PTO with
engine at idle speed.
Operating Speed
Various shredding conditions require different ground
speeds. Under most conditions, the tractor can be driven
between 3 and 7 MPH by using lower rpm’s and shifting
to a higher gear to maintain the needed ground speed
without causing undue wear on the shredder.
Operating Instructions
Hitch Pin
Safety
Locking
Pin
Getting Started
Pre-Start Checklist
• Grease the machine. See “Grease Point Location”
on page 36 for grease point locations.
• Adjust air in tires to recommended pressure.
• Check oil level in gearbox (maintain level to the
lower check plug hole on side of gearbox case). See
“Adding Oil to Gearbox” on page 38 for gearbox
oil information.
• Drive Belt tension – if belt needs adjustment, refer to
“Belt Tension” on page 21 for instructions.
• Check all bolts, nuts and set screws for tightness.
• Review operator’s manual.
Attaching the Windrow Shredder to Tractor
IMPORTANT:
Use a safety-locking pin when connecting
hitch pins.
DANGER:
Failure to install a safety locking
pin could result in loss of hitch pin, causing the
windrow shredder to become disconnected
from the tractor during operation, or in transport,
which could cause serious injury, or death, to
those near by.
Summary of Contents for 15
