Verricello Salpa Ancora mod. Titan
26
7 TROUBLE SHOOTING
Problem
Possible causes
Solution
1
The anchor windlass does
not work when a control is
operated
1.1
Protection switch in OFF position
1.2
Lack of voltage in the system
1.3
Failure of the control box
1.4
Failure of the control
1.5
Failure of the electric motor
1.1
Check the protection switch and set it in the ON position
1.2
Check the charge status of the battery, check connections
1.3
Check and possibly replace the control box
1.4
Check and possibly replace the control
1.5
Measure the electric motor voltage; if it is OK, check the brushes and clean them. If it does not
work, replace the electric motor
2
The chain jams frequently
2.1
The chain locker is not deep enough with respect to the
quantity of chain chosen
2.2
The chain is not suitable for the gipsy
2.3
The chain is not calibrated
2.1
Position the anchor windlass in the deepest point of the chain locker or reduce the quantity of
chain
2.2
Change the gipsy
2.3
Check the chain: if it does not meet the tolerances, it must be replaced
3
The anchor windlass turns
slowly
3.1
Unsuitable cable sections
3.2
Deck floors not parallel
3.3
Bad electrical connections
3.4
Dirty brushes
3.5
Water infiltrations in the electric motor
3.1
Increase cable section
3.2
Make floors parallel by interposing thicknesses
3.3
Check connections
3.4
Clean brushes
3.5
Replace the electric motor
