Product and Function
14
www.loepfe.com
WeftMaster CUT-iT
The 4 different current flow modes
Mode
Description
Off mode
Output current is switched off.
Display:
«POWER OFF»
(switched off)
Standby mode
Time in which the weaving machine is idle. Predefined current flows
through the cutting wires during this time. This achieves an optimum out-
put temperature for the machine to run.
Display:
«Standby»
Boost mode
Weaving machine starting phase. Predefined current flows through the
cutting wires for a limited time. This current heats the cutting wires as
quickly as possible to operating temperature.
Display:
«Boost»
(startup current)
Run mode
Time in which the weaving machine is running. The predefined current
flows through the cutting wires during this time.
Display:
«Run»
(running current)
The WeftMaster CUT-iT stops the weaving machine in the following cases
n
The power supply is interrupted.
n
A system error is detected.
n
No cutting wire is connected.
n
A cutting wire is broken (defective).
n
A connection cable is interrupted.
n
WeftMaster CUT-iT restarts.
3.2
Scope of Delivery
The following components are included in the scope of delivery:
n
1 control unit WeftMaster CUT-iT
Optional
n
Heat cutters depending on suitability:
– 1 heat cutter F Ceramic
– 1 heat cutter R Ceramic (short)
– 1 heat cutter R Ceramic (long)
– 1 heat cutter FL Ceramic
– 1 heat cutter F Steel
– 1 heat cutter F Steel with foot
n
Power supply 24 V DC
n
Auxiliary parts according to Spare Parts catalog
