3
3
Technical Data
3.1
Specifications
Loctite Model:
ZETA 7401
Loctite Part Number:
98039
Electrical Power Required:
120 VAC, 60 Hz single phase, 8 Amps maximum
Lamp Type, (visible and UV enhanced):
400 Watt Metal Halide
Dimensions L x W x H (inches):
18.5" x 10.75" x 10.5"
Total Weight
39 Pounds
4
Installation
4.1
Unpacking and Inspection
Carefully remove the system from its shipping carton and inspect it for any signs of damage.
Any damage should be reported immediately to the carrier. Refer to the list of supplied parts
(section 1.3) compare contents received to list of parts supplied. Report any missing parts
promptly to the Loctite customer service department at 1-800-LOCTITE (562-8483).
4.2
Installation and Start-up
The Loctite
®
ZETA
®
7401 UV curing system will arrive completely assembled. All that is required
is to plug in the power cord to the rear of the power supply. The system should be positioned to
allow at least six inches clearance on all sides for adequate ventilation.
Be sure to wear UV protective glasses and gloves at all times while operating the system.
A pair of each is supplied with the unit. To energize the system turn the power switch on and
allow 5 minutes for the lamp to reach full power. To maximize lamp life, the unit should be kept
under power without frequent on/off cycling. It is suggested that the lamp remain on during work
breaks. The lamp should be allowed to operate a minimum of 15 minutes before turning the
system off. Once off, a minimum of 5 minutes cooling time is required before restarting.
The position and exposure time required to complete the curing process must be determined
initially by testing cure time with an actual part.
