8
2 Description
The integrated electronic control can be adjusted according to the necessities of the
application.
The factory settings are:
– The rotor speed is set to 8,000 rpm (Switch position 9).
– The starting-up current is limited to 0.8 A (Dip switch
1
OFF).
– The monitoring time to reach the rated speed is set to switch position ON, that is
0.5 sec (Dip switch
2
OFF).
The monitoring time of 0.5 sec is an additional collision protection for small rotor disks.
When using bigger disks (> Dia. 40 mm) no monitoring time limit should be set.
If no monitoring time is set, then no error message will be generated, in case the speed
is not reached.
Changing of the factory settings, see Section 5.2.
