Installation guideline
Ⅲ、Mortise
installation
I n s e r t t h e
mortise into
the hole, fix
with ST4.8x19
screws from
t h e s i d e o f
door.
Ⅰ、Draw line
① D ra w a h o r i z o n ta l
center line with distance
of 1M from the inside and
outside to the grounds.
②Fold the template in
two, align the center line
of the handle with the
horizontal line of the door,
draw drilling lines of the
front and sides of door
according to the template
requirements.
Ⅱ、Drill hole
According to the template,
drill holes for lock panel and
mortise.
Ⅳ、Install square shaft
Insert the silver square shaft
special side on outside the
door, keep the length at
42±2 mm to the door , cut
off the extra part. Insert the
gold square shaft special side
on inside door, keep the
length at 29±2 mm, cut off
the extra part. The locks for
projects can be customized
a c c o r d i n g t o t h e d o o r
Ⅸ、Install battery
①Put battery into
battery box, and
cover the battery
cover.
② S e t u p d o o r
locks according
t o o p e r a t i o n
guidelines ,then
t e s t u n l o c k
function.
Ⅶ、
① I n s e r t a s l o t t e d
screwdriver into the
deadbolt slot to turn
the deadbolt, fine tune
the deadbolt to switch
flexibly. Tighten the link
screws.
②Open the cylinder
c o v e r , i n s e r t t h e
mechanical key and
turn the key clockwise
to the end, then push
down the handle to
check if the mechanical
key unlocking works
normal.
Ⅴ、Install front
panel
①Fit a waterproof
pad behind the front
panel.
②Place the spring
into the handle hole
of the front panel,
after insert the silver
square shaft, make
the silver square
shaft on front panel
align with square
s h a f t h o l e o f
mortise.
③ F l a t t h e f r o n t
panel on the outside
Ⅵ、Install back plate
①Fit a waterproof pad behind the
back plate
② C o n n e c t o n e c a b l e w i t h
mortise, and pull out another
cable on front panel to the
backside through the door holes
③Insert the slim square shaft with
slot through back plate align with
deadbolt hole on the mortise.
(pay attention to the direction).
When the deadbolt is not extend-
ed, the slot on the small square
shaft is inclined at 45 degrees to
the side of the door.
④Flat the back plate on the inside
door, fix the front panel with pack
plate by 2pcs M5 screws.
Ⅷ、Install back panel
①Connect the cable to the
back panel.
②Place the spring into the
handle hole of the back
panel, after insert the gold
square shaft, make the
gold square shaft on back
panel align with square
shaft hole of mortise. Fix
the panel on the back
panel with 4pcs M5 screws.
③Place the screw cap into
two screw holes at the
lower of back panel.
Ⅹ、Install strike plate
①Fit door with door
frame tightly, draw the
position of the latch on
the door frame with
pencil.
②Insert the strike box
and plate into the hole
according to the left
attached picture and
f a s t e n w i t h 4 p c s
screws.
③Check if the mortise
works properly or not.
