22
OPERATION
Match Holder
Rear view of cart
Match holder above doors
Match Holder
LIGHTING YOUR SMARTTEMP™
PRECISION GRIDDLE:
•
Read all instructions before lighting.
Only light burners outdoors.
• Open lid. Side shelves must be raised/
open.
• Make sure to clean and season
the cooking surface.
See “CARE &
MAINTENANCE” section.
1. Con
fi
rm that all control knobs
are in the OFF position as
pictured, with the LoCo logo
horizontal.
2. Open the LP tank valve fully by turning
counterclockwise.
3. Push in and turn any control
knob counterclockwise to
Lo
position.
4.
SureSpark™ Ignitor
Lighting:
Press and continually hold the
ignition button until the burner
is lit.
Repeat steps 3 and 4 to light
remaining burner.
TIP: After lighting . . .
Set your desired temperature and close the lid.
The SmartTemp™ control knob display will
cycle up to the set temperature.
Allow the control knob to cycle up twice before
cooking.
This dual cycling to the set temperature will
ensure that the cooking surface is heated
evenly.
5. If ignition does not occur in 5 seconds, turn
all control knobs clockwise to OFF, wait 5
minutes, then repeat the lighting procedure.
6. When the burners are lit, turn the control
knobs to the desired preset cooking
temperature.
Cooking Temperature Presets
Lo • 275F • 300F • 325F • 350F • 375F
400F • 450F • SEAR
Match Lighting:
Follow lighting steps 1 and 2. The match holder
is located beneath the control panel inside the
cart, secured by a chain.
Push in and turn left or right control knob
counterclockwise to the 275F position.
Place a match into the end of the match holder,
then insert the holder with lit match into the
large holes on the sides of cart to light the
burners.
