20
CONNECTING REGULATOR TO LP TANK:
1. Make sure LP tank is properly secured in
griddle cart.
2. Turn all control knobs to the OFF position.
3. Turn LP tank OFF by turning hand wheel
clockwise to a full stop.
4. Remove the protective cap from LP tank.
Always use cap and strap supplied with
valve. DO NOT use a POL transport plug. It
will defeat the safety feature of the valve.
5. Hold regulator, insert nipple into LP tank
valve. Hand-tighten the coupling nut while
holding the regulator in a straight line with
LP tank valve so as not to cross-thread the
connection.
6. Turn the coupling nut clockwise and tighten
to a full stop. The regulator will seal on the
backcheck. An additional one-half to three-
quarters turn is required to complete.
NOTE: If you cannot complete the
connection, repeat steps 5 and 6. If you are
still unable to complete the connection, DO
NOT use this regulator.
LEAK TESTING
Straight
Coupling Nut
Center nipple
in LP tank
valve
LEAK TESTING VALVES, HOSE AND
REGULATOR:
• A leak test is recommended before each
use and must be repeated each time LP
tank is exchanged or re
fi
lled.
• DO NOT smoke or have anything nearby
that can easily ignite, such as lighters or
matches.
• DO NOT use an open
fl
ame to check for gas
leaks.
• Appliance must be leak tested outdoors in a
well-ventilated area away from open
fl
ames
or sparks.
REGULATOR HOSE ASSEMBLY CHECK:
Clean and inspect the hose before each use of
the appliance. If there is evidence of abrasion,
wear, cuts or leaks the hose must be replaced
prior to the appliance being put into operation.
The replacement hose assembly must be the
one speci
fi
ed by the manufacturer.
Regulator
