20
PLUGGING IN YOUR GRIDDLE:
1. Con
fi
rm that the LP tank
valve is completely closed
(turn clockwise to a full stop)
and that all control knobs
are in the OFF position as
pictured, with the LoCo logo
horizontal.
2. Insert the small end of the power cord into
the power port on the cart’s left side panel.
3. Plug the cord into a GFI-protected outlet.
When not in use, store your power cord in the
drawer near the power port.
OPERATION
Power
Port
Power
Cord
Power Cord
Storage Drawer
LEAK TESTING
If “growing” bubbles appear, there is a
leak. Close LP tank valve immediately and
retighten connections. If leaks cannot be
stopped, do not try to repair. IMMEDIATELY
turn o
ff
LP tank valve. If bubbles continue,
IMMEDIATELY get away from the LP tank
and contact your FIRE DEPARTMENT (911).
WARNING
STEPS TO LEAK TEST:
1. Use a clean paintbrush and 50/50 soap and
water solution. Use mild soap and water.
DO NOT use household cleaning agents.
Damage to gas train components could
result.
2. Brush soapy solution onto all metal seams
and entire valve area of LP tank. Slowly turn
the LP tank valve counterclockwise to the
open position. At the
fi
rst sign of bubbles
around the tank connection, immediately
turn the valve o
ff
by turning clockwise. After
10 seconds, turn the LP tank valve to the
o
ff
position and continue to watch for any
bubbles. UNDER NO CIRCUMSTANCES
SHOULD THE VALVE REMAIN IN THE
OPEN POSITION FOR MORE THAN 12
SECONDS.
3. If bubbles are observed at the valve
attachment, you may attempt to tighten
the valve and repeat the test from the
beginning after waiting 5 minutes.
4. Brush soapy solution onto
shaded areas
shown below.
