14
lococookers.com
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner will not light.
Bad connection between the
regulator and LP tank.
Make sure the regulator
coupling nut is fully tightened on
the LP tank valve.
The LP tank is empty.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
Burner does not stay lit.
Excessive wind conditions.
When appliance is cool, move
appliance to different location
where high wind is not a factor.
Relight burner.
The LP tank is empty.
Refill LP tank at an authorized
dealer or purchase new filled LP
tank.
Water does not reach desired
cooking temperature.
Regulator control knob is not
fully opened.
Fully open regulator control
knob by rotating it in a clockwise
direction.
Overfill Protection Device (OPD)
on LP tank has been activated/
tripped.
To reset the Overfill Protection
Device, turn the regulator
control knob and the LP tank
valve OFF. Disconnect the
regulator from the LP tank
and wait at least one minute.
Reconnect the regulator to the
LP tank and fully open LP tank
valve.
Faulty or obstructed regulator
hose.
Contact customer service for
replacement regulator/hose
assembly.
DETERMINING THE MAXIMUM FILL LEVEL WHEN USING A VESSEL WITHOUT A MAXIMUM
FILL LINE:
1. Place your food into the basket.
2. Place the basket and food into the empty cooking vessel.
3. Fill the vessel with water just until the food is completely submerged. There must be a minimum
of 3 inches (8 cm) between the water level and the top of the vessel.
4. Remove the food from the cooking vessel and either mark the water level on the side of the
cooking vessel or measure the amount of water in the vessel.
5. This is the amount of cooking oil the vessel is to be filled with to cook your food.
6. Remove the water and completely dry the cooking vessel and your food.
