LockNet Security Doors
Document Part # 14003524 (Rev 021919)
Page 3 of 5
8.
Attach the strain relief on the armored power supply cable through the cover plate for
the armored door loop cable.
9.
Connect the armored power supply cable and the armored door loop cables using the
attached plug-in connectors.
10.
Mount the cover onto the armored door loop cable.
11.
Connect the transformer and the armored power cable using the attached plug-in
connectors.
12.
Make sure the
ON/OFF
switch on the Sur-Lock unit is in the
OFF
position.
13.
Plug the transformer into a wall receptacle. Make sure that the wall receptacle chosen is
NOT
controlled by a switch and that it is on at all times.
14.
Turn the
ON/OFF
switch on the Sur-Lock unit to the
ON
position.
15.
Test the panic bar to make sure it latches and unlocks properly. If necessary, adjust the
panic bar to insure proper operation.
Interior Side
Exterior Side
Figure 3:
Normal Keyless System
Component Mounting
Locations
Keypad
Transformer
Armored Cable
Armored
Door Loop
Sur-Lock Exit
Device
Transformer
Armored Cable
Armored
Door Loop
Sur-Lock Exit
Device
Keypad
Figure 4:
Alternate Mounting
Locations For Keyless
System
