11
7000INST Copyright Lockmasters, Inc. 5/25/11
Step 7 – Center punch and label holes
Step 7A
- Begin on the Inside Base Plate Template and use your hammer and center
punch to mark “punch” the following: (1) A, clutch hole: (6) B, front plate attaching
holes; (4) C, Inside Base Plate attaching holes; and (1) F, optional Wire Entry Hole
- Punch only if you are utilizing one or more of the following: 12 or 24v dc Access
Control input, Monitoring the position of the Combination Lock Bolt, and Monitoring
the position of the LKM7000 Dead Bolt/Request to Exit (REX). Potentially (12) holes.
Step 7B
– Re-tape the template above the punched holes for easy reference. Label
all the hole diameters from the template to the corresponding the holes on the door for
reference during drilling.
Tip: When labeling the holes note the hole
size next to the hole.
Step 7C
– Move to the front plate template, use your center punch to mark “punch” the
following (1) D, spindle hole and (6) E, front plate attaching holes.
Step 7D -
Re-tape the template above the punched holes for easy reference. Label all
the hole diameters from the template to the corresponding the holes on the door for
reference during drilling.
HOLLOW DOOR NOTICE: Due to alignment issues, you should
NEVER drill a through hole in a hollow door. To ensure a level
through hole, you should drill through one side of the door then
drill through the other side of the door.
LKM7000
Installation
7a - Center punch all applicable holes on IBP
template
7b - Move template and label holes for easy
reference during drilling.
7c - Center punch all applicable holes on Front
Plate template
7d - Move template and label holes for easy
reference during drilling.
