14
SECTION 3.6
NOTICE
Please make sure your fingers are clean from dirt
and oils before scanning your fingerprint. Make sure
the sensor is also clean by taking a soft cloth and
wiping the surface.
While in
Programming Mode*
, select
“1AD”
to add an Access Code. If you are not
in
Programming Mode
, please see
Section 3.2
to enter Programming Mode.
After pressing
“1AD”
press
“FP”
to register a Fingerprint.
Upon pressing
“FP”
, you
will enter
Fingerprint
Registration Mode
and
you will see a green LED
ring light up on the
fingerprint panel on the
exterior of Lockly Guard.
3.6 Adding a Fingerprint (Continued)
You must successfully scan your fingerprint
six (6) times
for it to properly register.
Every time you scan your fingerprint, the number on the bottom will change,
starting from
6
- then
5, 4, 3, 2, 1,
until the fingerprint is successfully registered.
Note: For reference, please keep a record of your
fingerprint registration
number
to distinguish whom it was registered to.
* Only works when lock is not paired with a smart phone device.
Once you’re in
Fingerprint
Registration Mode
you
will see two numbers
displayed on keypad.
The top number is your
Fingerprint Registration
number, in this example
to the left,
“1”
. The
bottom number will
always start with a
“6”.