5
英
語
／
E
N
G
L
IS
H
OPERATING THE AIR RIVETER
Select a rivet of a size which is suitable for the workpiece to be riveted.
Replace the nosepiece with one which matches the size of the rivet to be used.
(Refer to item in “
Preparation Before Use
” on page 5.)
Drill a hole of appropriate size (0.1 to 0.2 mm larger than the
diameter of the rivet) into the workpiece.
Insert the rivet into the hole.
ATTENTION:
Some rivets have shafts (mandrels) with sharp ends.
Be careful not to injure your fingers on these ends.
Place the nosepiece of the air riveter over the shaft (mandrel) of
the rivet.
Gently press the nosepiece of the air riveter against the
workpiece. After checking that there is no gap between the
nosepiece and the workpiece, pull the switch.
The rivet will be installed into the workpiece.
Release the trigger, and then tilt the air riveter to remove the cut mandrel from the
nosepiece or safety cap.
NOTE:
Make sure that the cut mandrel has been completely removed before proceeding to the next riveting.
＜
Operating temperature
＞
The ambient temperature for working is within the range of 4°C ~ 35°C (40°F~95°F).
1
2
5
3
4
5
6
7
8
( ? P + . / / Q - K - F ̟Ηل /.,3,04 //8.6 ?K ɚĘȸ3
