4
英
語
/
E
N
G
L
IS
H
1
2
3
4
Install the safety cap to the tool.
Set up the compressor, and be sure to
install an air filter and air regulator
between the compressor and the tool.
Use the air regulator to adjust the operating air
pressure to 0.49 ~ 0.59 MPa (5 ~ 6 kgf/cm
2
, 71 ~
85 psi).
t
WARNING 1 (P.1)
t
WARNING 2 (P.2)
AIR REGURATOR
AIR FILTER
SHAFT (MANDREL)
RIVET DIAMETER
RIVET (FLANGE)
PREPARATION BEFORE USE
ATTENTION:
If the air pressure is too high, damage
to parts may occur. If the pressure is
too low, some size of the rivet may not
be correctly installed (cut).
Replace the nosepiece to conform to the size
of the rivet being used.
The rivet size indicates the diameter of the rivet.
AR-011S AR-011M
AR-011H
Rivet Dia.
2.4 mm (3/32”)
3.2 mm (1/8”)
4.0 mm (5/32”)
4.8 mm (3/16”)
6.4 mm (1/4”)
2.4
3.2
2.4
3.2
4.0
4.8
2.4
(1.8 mm)
4.0
(2.9 mm)
3.2
(2.3 mm)
4.8
(3.3 mm)
6.4
(4.3 mm)
Nose piece Nose piece
Jaws
Jaw case
head
Jaw pusher
Nose piece
(Hole dia.)
“M”
“H”
“H”
“H”
“M”
“M”
Shaded areas indicate parts which are installed in the tool as standard accessories.
SAFTY CAP
FRAME CAP
SAFTY CAP NUT
¡
Different -sized rivets can be used just by replacing the nosepiece.
¡
At the time of purchase, the tools are fitted with a 3.2 mm (1/8”)
nosepiece.
¡
If you wish to use other sizes, use a spanner to remove and
replace the nosepiece.
AR-011S/AR-011M
¡
At the time of purchase, the tool is fitted with a 4.8 mm (3/16”)
nosepiece.
¡
2.4 mm (3/32”), 3.2mm (1/8”) and 4.0 mm (5/32”) rivets can be
used just by replacing the nosepiece.
¡
The tool is available to install 6.4 mm (1/4”) rivets subject to
conversion of jaws, jaw case head, jaw pusher and nosepiece.
(Refer to page 6)
AR-011H
t
CAUTION
Nose Piece Selection
Conform the size to be used, and replace the nose piece with the corresponding one.
Wrong size selection of the nose piece will cause jamming the spent mandrel inside.
( ? P + . / / Q - K - F ̟Ηل /.,3,04 //8.6 ?K ɚĘȸ2