7
4.2 How to take the load
Drive the truck slowly in front of the pallet. Then, drive the fork of the truck under
the pallet up to end of the fork length. (Pict 3.A).
Lift the load by pumping the handle at Raise position.The load must be on the
center of the hand pallet truck. Otherwise, the hand pallet truck can be overturned
4.3 Drive with load
It is not necessary to pump the pallet truck to the highest position to drive. You
must pay attention to the space between the bottom of the pallet and always keep
the pallet clear of the floor. You should carefully drive the hand pallet truck at a
stable speed paying due care and attention to the environment around you.
4.4 Lowering the Load
Lift the Lever to the Lower position, ensuring a free space behind. Then the truck
can be pulled out of the pallet.
4.5 How to use the hand pallet truck on the truck
Only move the pallet truck slowly, at all times be careful that the hand pallet truck
can not fall down from the truck or the user will not be in the middle between the
hand pallet truck and other loads. If the pallet truck is not used, it must be firmly
fixed on the truck when the truck is moving.
5.0
Service and warranty
5.1 Oil
The Hydraulic oil in the pallet truck is used for work condition of 6°C to 45°C only.
If the pallet truck is used in a temperature under 6°C , it must be used with other
Hydraulic oil with vicostity under 10.
Please check the oil lever every six months. The hydraulic oil volume in the pump
is 300 ml.
Used oil must be disposed off according to the latest regulations.
5.2 To remove the air
The air may come into the hydraulic oil because of transportation or pump in upset
position. It can cause that the forks do not elevate while pumping the RAISE
position. The air can be removed in the following way: Let the Lever (Part No. 51)
on the LOWER position, then move the Handle up and down several times.
5.3 Daily check and Maintenance
Daily check of the pallet truck can limit wear as much as possible. Special attention
should be paid to the wheels, the axles, as thread, rags, etc. It may block the
wheels. The forks should be unloaded and lowered in the lowest position when the
job is over.
Summary of Contents for XTN 540-1150
Page 13: ...13 ...
