5
3 To adjust the release device
On the handle of this hand pallet truck, you can find the lever, which operates in
three positions
:
Lower ................................ = Lowering the fork .......................... LOWER-Position
Drive ................................. = Drive the truck ................................... Drive-Position
Raise ................................ = Lift the fork ........................................ Raise-Position
If however they have been changed, you can adjust according to the following
steps
3.1
If the forks elevate while pumping in the DRIVE position, turn the adjusting
nut (Part No. 59) on the adjusting bolt (Part No. 58) clockwise until pumping
action does not raise the forks and the DRIVE position properly.
3.2
If the forks descend while pumping in the DRIVE position, turn the nut (Part
No. 59) counter-clockwise until the forks do not lower.
3.3
If the forks do not descend when the Lever is in the LOWER position, turn
the nut (Part No. 59) clockwise until raising the Lever (Part No. 51) lowers the
forks. Then check the DRIVE position according to item 3.1 and 3.2 to be
sure that the nut (Part No. 59) is in the proper position
.
3.4
If the forks do not elevate while pumping in RAISE position, turn the nut (Part
No. 59) counter-clockwise until the forks elevate while pumping in the RAISE
position. Then check the LOWER and DRIVE positions according to item 3.1,
3.2 and 3.3 .
Summary of Contents for XTN 540-1150
Page 13: ...13 ...
