SW500 Wired Scale Systems, Users
Rev E,October, 2016
Page 19 of 36
PRINT (Serial Output)
Press the PRINT key to go to the print menu. Press ‘1’ to print the screen (print
format is the same as the last active screen format). Here is an example of a
print layout:
Press ‘2’ for printing options. The following menu is displayed:
The above example shows that the continuous serial output is disabled. The
serial output is an externally available signal that can drive a numeric overhead
display board(s), a computer's RS-232 input, or other peripheral. To toggle the
continuous serial output choices, press ‘1’. There are 3 choices:
OFF
Continuous output disabled. Print screen enabled.
MULTI-LINE
Continuous output enabled, multi-line format
TOTAL ONLY
Continuous output enabled, total only format
In order to communicate, the baud rate of the SW scale must match the
peripheral you are connecting to. To change the baud rate press ‘2’. The active
baud rate will have a “*” to the right of it. Press the corresponding key to change
the baud rate.
See section ‘Serial Output’ for additional information.
INTERCOMP, U.S.A.
TEL: 763-476-2531
ACTUAL LBS
LF 232 RF 222
LR 241 RR 206
LEFT 52.50% C 51.39%
REAR 49.61% T 901
PRINTING OPTIONS
1: TOGGLE CONTINUOUS
(OFF )
2: SELECT BAUD RATE
