LNS Turbo HB, Instruction Manual

Page: 10 / 39

2-2 CHAPTER 2: SETTING INTO OPERATION
TURBO HB
2.1. Transportation
Please read the safety precautions described at the beginning of this manual before
handling the following devices.
Depending on its destination, the conveyor is normally secured to a pallet then heat sealed inside a
protective plastic cover. All shipping documents including this manual are also secured to the pallet.
Regardless of the type of packaging, the un-creating and lifting instructions recommended by LNS SA
must be observed in order to prevent any injuries to persons and damages to objects.
2.2. Unpacking
For practical and safety reasons, the conveyor must be unpacked in a spacious, well-lit location.
Check to see that the lifting capacity of the hoisting crane, or lift truck, is adequate before
proceeding with the handling of the merchandise. No one should be near the hanging load,
or within the operating range of the overhead hoist/crane, forklift, or any other means used
for lifting and transportation.
1)
If the conveyor is received as shown below start by removing the protective plastic material
2)
Cut any steel banding used to secure the conveyor to the pallet using side cutters (always wear
eye protection and gloves)
3)
Remove any screws holding the conveyor to the pallet (these may go through jacking or castor
plates.