LNS Super Hydrobar HS 3.26, Instruction Manual

Page: 18 / 44

2-12 CHAPTER 2: DESCRIPTION
SUPER HYDROBAR HS
Positionning the feet

Open the tube case by
raising its lid.

Remove the tube (see lifting
instructions).

Measure the distance (Y)
between the front of the tube
and the centring lugs. Place
the front foot at a distance
equivalent to Y+150mm from
the spindle exit.

Place the rear foot, leaving a
space (X) being the distance
between the centring ring at
the front and the indexing
ring at the rear of the tube.
To define (X), the measurement has to
be made as follows:
FIG.32a

On the centring ring (32a),
measure to the middle of the
horizontal (PH) and vertical (PV)
centring lugs

On the front foot, this point is
located between the horizontal
(32a/AH) and vertical (32alAV)
support plates.
On the indexing ring, measure to the
middle of the positioning groove (32b/R).
On the rear foot this point corresponds to the centre of the positioning
lugs (32b/G).
When the tube is in place, the front must to be
150mm from the exit to the spindle (Fig.33).