LNS Super Hydrobar HS 3.26, Instruction Manual

Page: 17 / 44

CHAPTER 2: DESCRIPTION 2-11
SUPER HYDROBAR HS
Préparation pour le montage
For mounting and installing the bar feed system, it is advisable to contact LNS or
one of its agents. The latter cannot be held responsible for any malfunction
resulting from an incorrect installation in which they did not take part.
INT
ERDIT !
FORBIDDEN !
VE
R
B
O
TE
N
!
PR
O
IB
IT
O
!
It is essential that the lathe be levelled before installation of the bar-feeder. The lathe
must be fitted with a collet or chuck in order to perform the bar rotation tests.
2.2.2. М ounting
Preparing the feet
Please refer to points 2.1.2. for the designation of the components
Open the oblong case by unscrewing the front plate. Inside you will find the hydraulic unit, the front and
back feet, the tube supports and all the small material you will need.

Align the feet approximate on the head stock. Then place
the levelling plates (see point 3.2) under the feet and
centre them on the level-adjusting screws. Level the feet.

Place the rear support (25/A) with the two guide pins on
the swivelling plate (25/B) of the rear foot and insert the
guide pin into it (25/D).

Pass the fixing bolt (25/C) though the dowel and screw it
tightly to the support. As the dowel (25/D) is thicker than
the swivelling plate, the support (25/B) remains free.

Tighten the safety screw (25/E), preventing the bolt (25/C)
from coming unscrewed.

Next place the front support (30/A) bearing the two
centring plates on the front foot (30/B). Also install the
loading arm (it is impossible to do this when the support is
fixed)

Insert the 4 fixing bolts (30/C) into the support plate and fix
the front support. When the bolts are blocked, it should
still be possible to move the loading arm.