START UP MANUAL
19
QUICK LOAD SERVO III
Note :
The
pneumatic
cylinders,
controlling
the vertical
movement of
the table,
release the
pressure to
allow motor
M2 to proceed
with the
setting. After
the setting is
complete, they
are
reactivated.
4.2
Calibration of the loading table
To obtain an optimal loading, the bar must be perfectly centered on the spindle,
regardless of its diameter or profile. Whenever the diameter or the profile is changed, the
position of the loading table is automatically adjusted according to the parameters entered
by the operator.
If, for any reason whatsoever, the position of the loading table would be incorrect (either
too low or too high), it can be corrected.
Procedure :
Conditions:
Bars are on the magazine
The loading table is in the low position
1.
Select manual mode by pressing the [F2]
key.
2.
Bring the loading table in upper position
[F2].
The bar now faces the spindle of the
lathe.
3.
The remote command offers icon [F4]
Forward. To obtain the icon [F3] Adjust
the height of the loading table, press the
[1] key.
4.
Press the [F3] key.
5.
Four icons are displayed :
[F1] raise the table
[F2] ESC (exit without saving)
[F3] ENTER (save)
[F4] lower the table
C
Each time the [F1] or [F4] key is pressed,
the vertical position of the table is
modified by 0.25 mm. For substantial
adjustments, keep pressing the key to
keep the table moving in a continuous
motion
C
When the desired position is reached,
press the [F3] ENTER key to validate the
choice and recalibrate the device at this new position. Since the calibration must be
changed, the command automatically accesses "Parameters related to set-up,
diameter, length, etc." (See Chapter 7 / point 5.2).
The command asks the operator to confirm the setting of the diameter. Using the
keypad, enter the diameter of the bar used to center the table. Press the [F3]
ENTER key twice to validate.
4.2.1 Profiled bars
The loading table of the Quick Load Servo II has been designed, in standard version, to
load various bar profiles. To load square bars, see the Instruction manual, Appendices /
Options for Quick Load Servo II.
