LNS FOX WS 2 1020, Instruction And Installation Manual

Page: 30 / 58

4-8 CHAPTER 4: INSTALLATION AND USE
SERIES WS 2- F190054000
90° extraction fitting installation
A 90° fitting can be installed in alternative to the standard fitting using the screws and nylon
washers as illustrated below:

Be careful to correctly position the gaskets.

Gradually tighten the screws.

Adequately tighten the screws but without exceeding to avoid damaging the nylon washers.
Extraction tube assembly:

Drill a hole of adequate dimensions if not found on the machine enclosure.

Secure the extraction fitting using the supplied nut and bolt set.

Drill 3 Ø 4 holes on the fitting base for oil drain.

Insert the extraction tube on the purifier extraction fitting and push to end stop.

Install the clamp so that it covers the top of the flexible hose.

Tighten the clamp.

Insert the other end of the flexible tube on the fitting installed on the machine tool.

Install the clamp on the tube and tighten.
Extraction fitting on machine tool
enclosure
Drill 3 Ø 4 holes to drain oil at the
sides of the fitting
Insert the extraction tube on the
fitting to end stop