www.lmicorporation.com 9
SECTION 3:
BATTERIES
3.1
BATTERY ICON
FULL
2/3 Capacity
1/3 Capacity
DEPLETED
Replace Battery
The battery icon indicates the condition of the batteries in the unit. The battery power level is
divided into three segments (see illustration above). As the batteries are depleted the display will
change as illustrated above. Depleted batteries must be replaced when all indicators have gone from
the display. If the indicator is connected with a USB cable; a USB PWR icon will display below the
battery icon. The unit is now powered via USB. Batteries are not required in this mode. Note: Data
will be lost if USB cable is removed and the batteries are depleted or missing.
3.2
CHANGING BATTERIES
When putting in new batteries, the digital indicator will store the tolerance limits, preset
values, and the mode the digital indicator was in before the batteries were replaced.
1.
Verify that the unit is turned off.
2.
Flip the digital indicator over so the LCD is facing down.
3.
Using a philips screwdriver, turn screw counterclockwise to
release cover.
NOTE: Screws will remain attached to cover.
4.
Remove battery cover.
5.
Pull out the old batteries and replace them with new AAA
alkaline batteries only.
6.
Ensure that the polarities are correct, when installing the
batteries. Po/- is clearly marked on the unit.
SECTION 4:
CHANGING CONTACT TIPS
1.
Hold the spindle with a pair of pliers and a clean piece of cloth
and with another pair of pliers holding the tip; turn the tip
counter clock wise to remove.
2.
Place the tip on the spindle and turn the tip to the right to tighten.
Then hold the spindle with a pair of pliers and a clean piece of
cloth and with another pair of pliers holding the tip; tighten the
tip to ensure that it is secure. Do not over tighten tip.
2
2
