9
1.5 Unpacking and Assembling UULA
This section describes how to unpack and assemble the UULA hardware.
Before you start, make sure that you have:
•
A PH2 screwdriver or a cordless drill.
•
A pump lift.
•
A 2 mm Allen key.
•
Phoenix Contact tool TSD 04 SAC (1208429) and SAC BIT M12-D15 (1208432) 0.4 N m.
At least two persons are required to install the device.
Proceed as follows:
1.
Place the plywood package in such a way that you can walk around it.
2.
Unfasten the screws (PH2) on the package lid.
3.
Remove the lid (number 1 in the figure below) of the plywood package.
4.
Remove the calibration mirror box and computer (if included) from the end plates.
5.
Unfasten the screws on the vertical corners and at the bottom edges of the package.
6.
Remove the sides (number 2 in the figure above).
Figure 3 Plywood Package and Calibration Mirror
