25
The system topology is now shown in the top left corner of the application. The center
part of the application shows configuration tabs, and the right half of the application is
occupied by visualization tabs. Selecting the Server entry in the device tree will bring up
system level configuration tabs to the right. Selecting individual sensors in the device
tree will bring up tabs to configure sensor specific settings.
Right-clicking an entry in the device tree brings up a pop-up menu. Assign a serial
number to each of the entries in the device tree, as shown below. A sensor can also be
temporarily disabled through this menu.
Select an individual sensor to bring up its configuration tabs, and then select the
Setup
tab. A sensor has an orientation, a multiplex time slot, and is viewing a particular vertex
of the system calibration target.
