llaza MONOBOX-400, Technical Manual

Page: 5 / 20

Page 5 - Copyright Llaza, S.A. - May 2011
Descriptive specifications
With proper use and under suitable conditions, SPLENDOR arms will exceed 60,000 operational cycles.
Also, the appropriate angular calculations for their components prevent them from rubbing against the fab-
ric during the entire extension-retraction process.
An installation with two arms can reach a maximum of up to five metres in width and 3.5 metres of projec-
tion. The Monobloc mounting system allows another identical structure to be added in parallel, both operat-
ed as a single system (see assembly instructions).
4. FINAL CONSIDERATIONS
■ Our manufacturing processes and corresponding management controls have allowed us to be granted
ISO 9001 certification for design and manufacturing.
■ Our compliance with the requirements of the European EN 13561 standard allows us to issue the State-
ment of Conformity for the CE marking.
■ The recommendations found in the TUV standards for strength and safety are rigorously followed.
■ Application of the conditions required by EAA/Qualicoat standards allow us to offer a 3-year guarantee on
lacquer finishes.
5. COMPONENT SPECIFICATIONS
GEOMETRIC PROPERTIES
Geometry Section (mm2) Mt (cm4)
Structure
Structural profile 40x40x3 444 Ixx = 10.19 Iyy = 10.19
Wall support
-
3361 Ixx = 438.8 Iyy = 277.7
Ceiling support
-
7122 Ixx = 5403 Iyy = 898
Cassette profile
-
805 Ixx = 79 Iyy = 255.9
Weather cover
-
687 Ixx = 4.6 Iyy = 164.9
Front drop bar
-
1253 Ixx = 429.6 Iyy = 39.58
SPLENDOR model arms
Structural components
- - -
Front aluminium profile
-
319 Ixx = 17.53 Iyy = 39.58
Rear aluminium profile
-
379 Ixx = 22.90 Iyy = 77.88
TECHNICAL CHARACTERISTICS
Structure Process Desig. Material A B C D
Components Pressure moulding Aluminium 180 90 2,5 55
Structural profile Extrusion Aluminium 175 130 6
-
Wall support Extrusion Aluminium 160 110 5
-
Ceiling support
Extrusion Aluminium 260 215 6
-
Cassette profile Extrusion Aluminium 175 130 6
-
Weather cover
Extrusion Aluminium 175 130 6
Front drop bar Extrusion Aluminium 175 130 6
Extrusion comp. Extrusion Aluminium 160 110 5
SPLENDOR model arms
Components
Pressure moulding Aluminium 180 90 2,5 55
Front alum. profile
Extrusion Aluminium 175 130 6
-
Rear alum. profile Extrusion Aluminium 175 130 6
-
MONOBOX-400