3 (8)
EN.29.C.46.20200318
Assembly instructions | LK Wallbox UNI Push AX16 V2 and AX20
1.9. Assemble the sleeve coupling on the wallbox’s
casing with a rotating movement until it stops, so
that it locks firmly.
NOTE!
Check that at least one groove on the conduit is
visible above the rubber gasket in the sleeve
coupling, and that the gasket is midway
between two grooves on the conduit.
1.6. Mark the insertion depth on the pipe. The
insertion depth should be 20 mm on the 16 mm
pipe and 23 mm on 20 mm pipe. The yardstick
at LK Smart Tool Push AX (RSK 188 25 49) will
facilitate it.
1.7. Loosen the sleeve coupling and pull out the
clip on the 16 mm wall box and on the 20 mm
wall box it should remain. Then guide the sleeve
coupling on the conduit.
Check that the insert is mounted in the fitting
.
1.8. LK Universal Pipe is now inserted into the
PushFit coupling with a firm rotating movement
until it resists and the marking of the insertion
depth is barely visible. Then pull the pipe to ensure
that it is secured fi rmly in the coupling.
To facilitate installation of LK Universal Pipe in
the fitting, use
LK Manual Pipe Grip Plier
(Article no. 188 11 03).