3
EN.33.C.152.1405
Assembly instructions | LK Room Temperature Control ICS.2
Check to ensure the antenna is connected properly.
Energise the receiver.
Learning for 1 (optional) receiver as Master unit
by holding the L and A buttons until the lights
for L and all channel LEDs lights are lit with a
green light. This shows that this unit is set as
the Master unit.
Learning for the Master unit is made for an op-
tional receiver if there are several in the system.
Press the L button once. This turns off all
the lights on the unit and confirms/exits
the learning sequence for the Master unit.
It is important to check that all lights are off be-
fore continuing with the rest of the installation
steps. This is to avoid conflicts during the ongo-
ing installation process.
Remember to mark the unit as Master unit on
the sticker in the unit's cover.
Note:
Steps 5 to 8 are only performed in sys-
tems with multiple receivers that are to com-
municate over a network!
Set the
Master unit
to learning mode by press-
ing the L button until the light is solid green.
The Master unit goes into learning mode to
communicate with the other receivers (Slave
units).
1
2
3
4
5
