LK Systems ICS.2, Assembly Instructions Manual

Page: 24 / 25

24
EN.33.C.152.1405
Assembly instructions | LK Room Temperature Control ICS.2
Table of error codes
Error
code
Description R indicates RT indi-
cates
Things to do Comment
1 No communication
has taken place in 60
minutes
Red light on the
current channel
light
01 ERR Check the signal path,
antennas and contacts. The
distance may be too great.
2 No communication
between R - R
Red light on the L
light for R
02 ERR Check the signal path,
antennas and contacts.
The distance may be too
great. Otherwise reset R
to establish new contact
R sends error code to all
RTs
3 No R in radio range for
RT
- Icon for
radio mast
flashing
Check the signal path,
antennas and contacts.
The distance may be too
great. Otherwise reset RT
to establish new contact
RT tries to send error to R
4 Dual network ID Red light on R L
light
- Reset R Another R has the same
network ID
5 R cannot go into learn-
ing mode
Red light blinking
3x on R L light
- Exit learning mode on
another R
Another R is in learning
mode
6 Wired RT learning error - 06 ERR Press SET Check steps for learning
7 Wireless RT learning
error
- 07 ERR Press SET Another RT is in learning
mode with R
8 Wireless RT learning
error
- 08 ERR Press SET R is not set in learning
mode
9 Shorting actuator Red light flashing
for current channel.
09 ERR Reset the error by cutting
power supply. Check the
actuator if error recurs.
R sends error code to RT
10 Total voltage for actua-
tor outputs too high
Red light on R L
light
10 ERR Error occurs when too
many actuators connect-
ed, either per output or
total for entire R.
Check the number of
actuators. Reset error by
cutting the power supply
R sends error code to RT
11 Actuator overloaded Red light flashing
for current channel.
12 ERR Check connected actuator R sends error code to RT
12 Thermostat error Red light for current
channel.
13 ERR Reset RT.
Note: Error code indicated
if possible.
-
13 Error in floor sensor Red light for current
channel.
14 ERR Check sensor connection RT sends error code to R
14 Error in room sensor Red light for current
channel.
15 ERR Contact LK RT sends error code to R
15 Low battery level Red light for current
channel.
Flashing
battery icon
Replace batteries. RT sends error code to R
16 Logging error Red light on
U light
17 ERR R sends error code to RT
17 Error in USB connection Red light on
U light
- Pull out and insert LK ICS
Mem stick. If problem per-
sists, try another stick.
Applies when logging to
LK ICS Mem Stick.
18 R learning error Red light on R
L light.
- Press the L button to
return to the starting
position.
R was not programmed as
Master or Slave. Cannot
communicate with the Master
when set in learning mode.
R = Receiver
RT = Room thermostat