- 7 -
5. Reset Button and Transmitter LED
In the event the ourdoor sensor is not transmitting, reset the outdoor sensor.
With an open ended paperclip, press and hold the RESET BUTTON for three seconds to completely
discharge the voltage.
Take out the batteries and wait one minute, while covering the solar panel to drain the voltage.
Put batteries back in and resynchronize with console by powering down and up the console with the sensor
about 10 feet away.
Figure 10
Indoor sensor
Remove the battery door on the back of the sensor with a Philips screwdriver (there is only one screw, at
the bottom of the unit). Insert two AAA batteries as shown in Figure 10 (we recommend lithium batteries for
cold weather climates, but alkaline batteries are sufficient for most climates).
Replace the battery door and set screw. Note that the temperature, humidity and pressure will be displayed
on the LCD display. Looking at the back of the unit from left to right, the polarity is (-) (+) for the top battery
and (+) (-) for the bottom battery.
Figure 10
LED
RESET BUTTON
