page 8 of 29
5. Operation
5.1 Unlocking
Insert the key pin into the red connector at the bottom of the housing of
the laser shower PowerTwin21
(● p
age 4, fig. 1/7)
.
The adapter ring for the
laser shower or laser comb must be plugged in (
●
section 9, “Replacing the
Adapters”, page 15, resp. page 4, figures 2/10+11
).
The PowerTwin21 cannot be operated without the adapter ring. Only the
power supply unit AC/DC adapter type FW7555M/12 which was shipped with
the unit must be used.
Connect AC adapter with adapter plug
The power supply unit (AC adapter) and the PowerTwin21 are connected with
an intermediate plug. Should you wish to remove the power supply unit from
the laser shower PowerTwin21, please proceed as follows:
Slightly push back the locking device (black sleeve)
at the plug, and pull the two plugs apart.
Attention!
The plug-in connection is a push-pull locking system. Hold the plug-in
connection only by the sleeves with the arrows, as illustrated. Never twist
the plugs or pull at the back ends of the plug.
If you reconnect the PowerTwin21 with the AC adapter, make sure you
observe the direction of the arrows on the plugs.
5.2 Connect AC Adapter to the power supply
Connect the AC adapter to the mains (100–240 V~). A correct connection is
indicated by a green control light at the AC adapter.
5.3 Initial settings after booting
After switching the device on, the output data of your lasersystem (wavelength
and max. output) are indicated in the second line.
PowerTwin21
785nm 21x50mW