12 GB
Never direct the LED light beam on to reflective surfaces or at
people or animals. Failure to observe this advice may result in eye
injury and / or loss of sight to people or animals. Even a weak LED
light beam can cause eye damage.
Place the product on a flat surface with its back side facing you.
Insert the connection plug of the mains adapter
9
into the con-
nection socket
7
on the back of the product.
Plug the mains adapter
9
into a properly installed socket.
Adjusting the product
Note:
Only change the alignment of the product when it is turned off.
You can adjust the product to the lighting conditions you require.
To do so, use the four joints:
1. Turning joint with lamp base
6
: the lamp arm
2
can be turned
approx. 22.5° in both directions from the midpoint.
2. Lower tilt joint: with this you can move the lamp arm
2
approx.
90° upwards or downwards.
3. Upper tilt joint: with this you can move the lamp head
1
approx.
135° upwards or downwards.
4. Turning joint in the lamp head
1
: with this you can turn the lamp
head
1
90° in both directions.
Turning the product on / off
To switch on the product, press the ON / OFF button
3
on the
lamp base
6
.
