15
GB/IE
Introduction / Safety
1 Glass plate
2 Chrome decorative rings for GU10 light bulbs
4 LED light bulbs, E14, 5.5 W
2 LED light bulbs, GU10, 5 W
2 Spacers
4 Washers
2 Locating screws
1 Instructions for assembly and use
Parts description
1
Plugs
2
Mounting bracket
3
Screws (mounting bracket)
4
Connection housing
5
Light arms (14107908L and 14108108L)
6
Plugs (ceiling mount) (14107908L and
14108108L)
7
Ceiling mount (14107908L and 14108108L)
8
Screw (14107908L and 14108108L)
9
Ceiling mount clip (14107908L and 14108108L)
10
Spotlight
11
Locating screws (connection housing)
12
Mains connection cable (external)
13
Protective tube
14
Terminal block
15
Pin (14107908L and 14108002L)
16
Protective ring (14107908L and 14108002L)
17
Light glass
18
Light bulb
19
Spacer (14108002L)
20
Washer (14108002L)
21
Washer (14108002L)
22
Locating screw (14108002L)
23
Chrome decorative ring (14108002L)
24
Glass plate (14108002L)
25
Screw (14108002L)
26
Threaded ring (14108108L)
27
Tool (14108108L)
Technical Data
Item no.:
14107908L or 14108002L
or 14108108L
Operating voltage: 230 V ∼, 50 Hz
Light bulb:
E14 max. 5.5 W,
220–240 V~ 50 Hz
14108002L additionally:
GU10, max. 5 W,
220–240 V~ 50 Hz
Rated output max.: 6 x 5,5 W (14107908L /
14108108L)
2 x 5 W GU10 + 4 x 5,5 W
E14 (14108002L)
Protection category: I
Safety
Safety notices
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or person-
al injury due to improper handling or failure to
comply with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
Always check the light, power supply, and
mains cable for damage before plugging it in.
Never use the light if it shows any signs of
damage.
A damaged mains cable indi-
cates a life-threatening danger due to electric
shock. In the event of damage, repairs or other
problems with the light please contact the
service centre or a qualified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (see chapter „Technical
Data“).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
