![background image](http://html1.mh-extra.com/html/little-wonder/bedshaper/bedshaper_owners-manual-and-safety-instructions_1929693015.webp)
13
LITTLE WONDER
BEDSHAPER
MAINTENANCE / ADJUSTMENTS
LUBRICATE BLADE SHAFT & AXLE BEARINGS:
DO NOT OVER FILL. TOO MUCH PRESSURE
WILL DAMAGE BEARING SEALS.
1. Locate and clean fittings
2 & 3
on both sides of
machine.
2. Pump fittings full of grease using a hand pump.
LUBRICATE BLADE ARM FITTINGS:
1. Locate and clean fittings
1
on both sides of arm.
2. Pump fittings full of grease using a hand pump.
ADJUSTMENT - DIRT SCRAPER GAP:
BEFORE ANY MAINTENANCE OR ADJUST TO
THE MACHINE, ALWAYS STOP ENGINE, DISCON-
NECT SPARK PLUG WIRE, AND ALLOW COM-
PONENTS TO COOL. WEAR GLOVES. ALWAYS
WEAR EYE PROTECTION WHEN CLEANING THE
MACHINE.
1. Allow blade time to cool.
2. Raise Blade Lift lever into transport position.
3. Examine gap between blade and dirt scraper.
NOTE: Recommended gap is 1/2" (1.3 cm).
4. Adjust gap, if necessary. Loosen the tow bolts
which secure dirt scraper. Adjust gap to 1/2" (1.3
cm). Tighten bolts.
6. Rotate blade at least one full revolution. Check
to see the blade does not contact dirt scraper. If
contact is made, repeat steps and increase gap.
It is important that the dirt scraper DOES NOT
touch the blade.
7. Tighten bolts securely.
ADJUSTMENT TRANSMISSION DRIVE CHAIN:
1. Chain should be snug for proper operation.
Adjust by loosening tension black and sliding
rearward. Do not over tighten chain. Rotate
drive by hand to ensure chain is not over
tensioned at any one spot.