Fig. 3
Fig. 4
The product should be periodically examined for potentially unsafe conditions such as: damaged cord, plug, housing, etc. In the event such
damage is found, the product should not be used until properly repaired. Refer to the instructions for set-up, storage, maintenance and care.
To clean use mild detergent and water.
4. With the ON/OFF switch in the OFF (0) position, and the INFLATE/RESET/DEFLATE knob in the RESET position, open the
cord storage area door and carefully extend the cord. (Fig. 2)
5. Plug the cord into the wall outlet.
6. Turn the ON/OFF switch to ON and rotate the INFLATE/DEFLATE knob to INFLATE. (Fig. 2)
7. Allow the Bouncer to inflate until it is firm but the seams still show slight wrinkling then turn the knob to RESET and turn
the ON/OFF switch to OFF. (DO NOT over-inflate.)
NOTE: The knob must be completely centered at RESET to prevent deflation. (Fig. 2A)
8. Place the power cord in the control panel cord storage door prior to allowing children to play on the unit.
In the event the bouncer is accidentally punctured, an adult must perform the following steps:
12. Deflate the item, clean the punctured area with water and allow it to dry.
13. Cut a portion of the patch allowing approximately 1
1
/
2
inches of excess patch material on all sides of the opening to be patched and
round the corners.
14. Remove the backing from the patch material, position the patch over the damaged area and smooth out any bubbles with a
paper towel.
15. Allow the item to sit for 30 minutes before re-inflating.
Fig. 2
To deflate the bouncer:
9. Open the large air outlet near the control panel. (Fig 3)
10. Turn the knob on the control panel to DEFLATE and the ON/OFF switch to ON.
11. Once deflated, turn the ON/OFF switch to OFF. Unplug the unit and store the cord inside the control panel door. (Fig. 4)
DEFLATING THE BOUNCER
REPAIRING A PUNCTURE
MAINTENANCE
OPEN
FOR
CORD
STORAGE
ON (I)/OFF (O)
DEFLATE
INFLATE
RESET
Fig. 2A
WARNING:
2
3
ADULT SUPERVISION AND SET UP REQUIRED. This product should be inflated or deflated by a competent adult.
1. Not for outdoor use. Sudden gusts of wind can lift the product
off the ground.
2. Minimum clearance zones of 6.6 ft. (2 m) in any direction are
required.
3. Keep the area around the product clean and clear of objects to
prevent slips and falls.
4. DO NOT allow attachment of items such as jump ropes, pet
leashes, cables, etc., to product as they may cause a
strangulation hazard.
5. DO NOT drag the unit as doing so may cause irreparable
damage.
6. Ensure the play area is free from hazards such as furniture, walls,
sharp objects and other hard surfaces before inflating the unit
and playing in it.
7. DO NOT leave children unattended at any time.
8. DO NOT use the unit if it is wet as it may become slippery.
9. DO NOT allow children to play in the product until it is fully
inflated.
10. Children must remove helmets, loose clothing, scarves,
headgear, shoes and glasses, as well as any sharp objects from
their pockets, as they may puncture the bouncing surface.
11. Toys and other objects should never be allowed inside the
bouncer.
12. Keep pets away from the product.
13. Children should bounce away from others and stay away from
openings and side walls.
14. DO NOT allow food, drink or gum inside unit.
15. Maximum user weight is 60 lbs. (27 kg). Total weight of children
must not exceed 120 lbs. (54 kg).
16. No more than 2 children should play on the bouncer at the same
time.
17. DO NOT use extension cords with this product.
18. THIS IS NOT A FLOTATION DEVICE. DO NOT USE IN OR NEAR WATER.
19. DO NOT allow children to play together who are unevenly matched
in weight and height.
20. Prior to deflating, remove all children.
21. Always deflate product after use, and store indoors.
22. Users must be discouraged from attempting any unauthorized
modification.
23. Remove the plug from the socket before use.
· To reduce the risk of electric shock, use indoors only.
· Remove the bouncer plug from the electrical outlet before cleaning.
· Allow the unit to cool down for 3 minutes after 5 minutes of continuous pump operation.
· The pump contains a thermal switch that will automatically shut down the unit if it gets too hot. To reset, turn the pump switch to OFF and
unplug the unit from the AC outlet to allow it to cool. The pump will function properly once normal temperatures are reached.
· Do not use the electric pump near wet surfaces or if water has entered the pump.
· Do not immerse the bouncer pump in water or cleaning liquid.
· Always keep the power cord away from hot surfaces. If the power cord or plug is damaged, contact consumer service.
· This appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. Do not change the plug in any way.
· Do not place the power cord under the bed, furniture or carpet coverings.
IMPORTANT PUMP INFORMATION
The pump is not serviceable. Do not attempt to service the pump. Doing so may cause the warranty to be voided.
WARNING:
3. Check that the buckles on the slide are properly adjusted. If necessary, twist the connector to tighten. (Fig 1)
INFLATING THE BOUNCER
ADJUST
BUCKLE
ADJUST
BUCKLE
TWIST TO TIGHTEN
Fig. 1
