9
2
UL
US
LISTED
E230679
1
2
Grounded
Outlet
Grounding
Pin
Sketch A
T
S
E
T
T
E
S
E
R
SAFETY WARNINGS: ELECTRICAL BLOWER
DO NOT IMMERSE IN WATER OR USE NEAR OR IN
CONTACT WITH WATER.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
ADULT SET-UP AND SUPERVISION REQUIRED.
USE ONLY ON GROUNDED OUTLETS
CAUTION
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product is for use on a nominal 120 Volt, 15 Ampere supply circuit, with grounded outlets
(sketch A) wired in accordance with all local electrical codes and ordinances. Make sure that the circuit
is not overloaded while the blower is in operation. If the outlet is dissimilar to the one illustrated in the
sketch, do not try to use temporary adapters, or modify the plug. Do not use the product until a properly
grounded outlet is installed by a qualified electrician.
GROUNDING METHODS
BLOWER SPECIFICATIONS: MODEL: W-2L
ELECTRICAL RATING: 115V AC, 60HZ, 3.8A, 437W
Specifications may change without notice.
CAUTION: The blower is a high volume blower, and is capable of moving large volumes of air very quickly. Place
the blower in an area where it will not draw in dirt or leaves. Keep the blower and power cord away from children,
pets, bodies of water, pools, spas, and traffic.
INSTRUCTIONS FOR BLOWER INSTALLATION AND OPERATION
NOTE:
Set up as close to the power source as possible. The product should be periodically examined for potentially unsafe conditions such
as: damaged cord, plug, housing or parts, and in the event such damage is found, the product should not be used until properly repaired.
Never leave the blower outside in the rain or exposed to the elements when not in use. When in use, do not place the cord across traffic
areas, water or damp areas. The blower should be placed on a stable surface and anchored per product instructions. The power cord of the
blower is equipped with a Ground Fault Current Interrupter (GFCI) plug.
1) Make sure that power switch of the blower is in the “OFF” position. Plug the blower into a properly grounded outlet.
2) If the GFCI has been tripped, press the “RESET” button to restore power to the blower.
3) Set the power switch of the blower to “ON” to inflate. After use, turn the power to “OFF”.
4) To disconnect the plug, have an adult grip it tightly and pull it from the wall outlet.
WARNING:
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require any
lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a dry place.
Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
Repair Kit Instructions
WARNING:NOT A TOY.ADULT USE ONLY.
Repair kit. Keep away from children
REPAIR PATCH INSTRUCTION
1. Deflate the item, clean the damaged area and allow it to dry thoroughly.
2. Cut a portion of the patch allowing to the size needed and round the corners. (See Fig. 1 & 2).
3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-inflating.
WARNING:
Repair patches must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.
!
• As an outdoor product the inflatable is subject to wear and
deterioration. Inspect for signs of fabric failure; weak or
torn surfaces must be repaired promptly.
• Product should never be stored wet. Allow to dry before
rolling up.
• Surface washable only.
Maintenance
Instructions for
Blower Maintenance
• Disassemble and dispose of the equipment in a
safe manner so as not to produce hazardous conditions.
• Blower should be returned to a collection center capable of
processing electrical/electronic waste.
Disposal
• Blower must be unplugged before servicing.
• Product should be periodically examined for potentially
unsafe conditions such as damaged cord, plug, housing,
or parts, and in the event such damage is found, the
product should not be used until properly repaired.
• The blower does not require any lubrication and has no
user serviceable parts. Do not attempt to service the blower.
• Do not immerse the blower in water. To clean, wipe with a
damp cloth.
• Regularly inspect the intake and output openings and keep
free of dirt, leaves, etc.
• When not in use, store the blower indoors in a dry place.
• Store the blower upright on a stable surface.
• Loosely coil the cord and place it beside the blower.
• When in use, do not place the cord across traffi c areas,
water or damp area.
• The blower is a high volume blower, and is capable of
moving large volumes of air very quickly. Place the blower
in an area where it will not draw in dirt or leaves.
• Adult installation and supervision required.
• This blower is for residential use only. It is not intended to be used in commercial or industrial settings.
• Never insert fingers, pencils or any other object through the grill at ANY time.
• Do not operate blower with a damaged cord or plug.
• Do not operate in the presence of explosive and/or flammable fumes.
• Never connect the blower to any solid – state speed control device.
• Do not use extension cords.
• Always unplug the blower before servicing.
