Z8F3224 ZMOTION Development Kit
UM029501-0321
CONNECT ZMOTIONL400 DEV BOARD AND PC
User Manual
17
2. Place switch SW4 into the NP position.
3. Connect one end of the 6-circuit ribbon cable provided in your Kit to the SmartCable debugger,
ensuring that the ribbon’s male connector is aligned correctly with the female connector on the
unit, as indicated by the red stripe in the following figure.
Figure 12. Connecting the 6-Circuit Ribbon Cable to the SmartCable
4. Connect the other end of the ribbon cable to NP Debug Connector J8 on the Development
Board. Ensure that Pin 1 on the ribbon cable is aligned with Pin 1 on the target connector, as
shown in the following figure.
Figure 13. Connecting Ribbon Cable to NP Debug Connector J8
Encore! SmartCable or
USB SmartCable
