INSTALLATION INSTRUCTIONS SUPPLEMENT
F OPTION (DC FLASHER)
LVS/LVS2 120/277 ELN F EMERGENCY EXIT SIGNS
FIGURE E 120V SINGLE LAMP F OPTION
FIGURE F 277V SINGLE LAMP F OPTION
INSTALLATION
1. Refer to IMPORTANT SAFEGUARDS (opposite side)
before proceeding.
2
. Follow installation instructions provided with exit fixture, but
for all wiring connections refer to wiring diagrams Fig. E,
Fig. F, Fig. G, or Fig. H.
NOTE: This exit is provided with a FLASHER and is
intended for installation in locations where permitted by local
codes.
FLASH RATE: 66 CPM
DUTY CYCLE: 50/50
INSPECTION
1. NOTE: Emergency lighting systems should be tested as
often as local codes require, or at least monthly to acertain
that all componants are operational.
2
. Normal Operation: When unit is functioning properly,
with A.C. power supplied, the green ready light and lamp
will be on.
3. To Test "F" Option: Actuate "Test" switch. green ready
light will go out and lamp should flash in D.C. mode.
Part Number EMCSA00457
rev. PA
FIGURE G 120V DUAL LAMP F OPTION
FIGURE H 277V DUAL LAMP F OPTION
EMERGENCY LIGHTING SYSTEMS
TEL: 800-334-8694 Fax: 770-981-8141 www.lithonia.com
