3. Installation Preparation.
page 3
ON
OFF
ON
OFF
ON
OFF
ON
OFF
4. Hanging Bracket Installation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 225
square feet (20.9 square meters).
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position.
WARNING:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure
the outlet box is securely attached to the building
structure and can support the full weight of the fan.
Ensure outlet box is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved
outlet box. Failure to do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and
that a ground wire (green or bare) is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box. Pull electrical wiring from
outlet box through center hole in the hanging
bracket.
*Note
:
It is very important that you use the proper
hardware when installing the hanging bracket as this
will support the fan.
This fan can be mounted
only
as a
flushmount
on a regular ceiling.
Downrod
installations are
not
available for this fan.
hanging bracket
spring washers
outlet box screws
flat washers
flushmount
installation
downrod
installation
CANNOT be
installed on
angled or
vaulted ceilings
blade edge
7 feet
(2.13m)
(76cm)
30
inches
12 f
t.
- 15 f
t.
12 ft. - 15 ft.
(3.66m - 4.57m)
(3.66m - 4.57m)
