4
WIRING
(continued on the following page)
Fig. 1
Fig. 2
NORMAL OR ANGLE STYLE FAN MOUNTING
Fig. 3
E
E
D
R
C
B
B
A
S
A
A
FAN AND LIGHT CONTROLLED BY CHAIN.
FAN CONTROLLED BY CHAIN, LIGHT BY WALL SWITCH.
BLACK (POWER)
WHITE (NEUTRAL)
GROUND
BLACK
WHITE
Fig. 1A
Fig. 1B
BLUE
GROUND
BLACK (POWER)
WHITE (NEUTRAL)
GROUND
BLACK
WHITE
GROUND
SWITCHED
LIGHT
POWER
BLUE
WARNING:
To reduce the risk of fire, electrical shock,
or personal injury, wire connectors provided with this fan are
designed to accept only one 12 gauge house wire and two lead
wires from the fan. If your house wire is larger than 12 gauge
or there is more than one house wire to connect to the two fan
lead wires, consult an electrician for the proper size wire
connectors to use.
Important:
Be sure wiring box is properly grounded or
that a ground wire (green or bare) is present.
1.
Choose wiring diagram [Fig. 1A, Fig. 1B or Fig. 1C] that fits
your situation and make appropriate wiring connections as
follows: (
Make special note of Step 3 on the following page
while wiring.
)
1A.
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector (O) provided. Connect
WHITE
wire from fan to
WHITE
wire from ceiling with wire
connector (O) provided. Connect all
GROUND
(
GREEN
)
wires together from fan to
BARE
/
GREEN
wire from ceiling
with wire connector (O) provided. [Fig. 1A]
1B.
If you intend to control the fan light with a separate wall
switch, wire as indicated in the instructions in 1A
except
connect
BLUE
wire from fan to the
BLACK
supply from the
independent switch. [Fig. 1B]
[
See next page for 1C
.]
Warning:
If house wires are different colors than
referred to in following steps, stop immediately. A professional
electrician is recommended to determine wiring.
2.
Remove pin (R) and clip (S) from motor housing yoke. Slip
downrod (A) into motor housing yoke, align holes and re-install pin
(R) and clip (S). Tighten downrod (A) set screws and then tighten
nuts. Slide yoke cover (E) down until it rests on top of motor
housing (D). [Fig. 2]
3.
Install ball end of downrod (A) into mounting bracket (C)
opening. Align slot in ball with tab in mounting bracket (C). [Fig. 3]
Warning:
Failure to align slot in ball with tab may result in
serious injury or death.
1.
Insert downrod (A) through canopy (B), canopy cover (X) and yoke
cover (E). (
Note:
Canopy cover (X) must be turned with the shiny
side
toward
the motor housing (D). [Fig. 1] Thread wires from motor
housing (D) through downrod (A).
*Helpful Hint:
Downrod style mounting is best suited for ceilings 8 ft.
(2.44 m) high or higher. For taller ceilings you may want to use a
longer downrod (not included) than the one provided. Angle style
mounting is best suited for angled or vaulted ceilings. A longer
downrod is sometimes necessary to ensure proper blade clearance.
X
Set
Screw
