5
MOTION SENSOR
INSTALLATION
5.
Mate male connector of sensor and
pre-connected input cable (removed in
step 3) or any chosen Litetronics cable
accessory by twisting clockwise.
7.
To set sensor functionality, remove screw
from plastic cover and then unscrew top
cover from sensor assembly. You will see
dip switch. See MC031V settings on next
page (6). Replace sensor cover and screw.
8.
Restore power at circuit breaker and
subsequently switch on dimmer
(if applicable) and enjoy High Bay
luminaire.
6.
Connect 0-10V gray and purple wire of
High Bay and sensor with help of wire nuts
(waterproof) provided with High Bay.
Assure that sensor lens is parallel to surface of lens by adjusting the
hinge screws.
Motion Sensor_Installation Instructions_v1.indd 5
2/16/2018 8:37:39 AM
